Load Cell - Wire Rope Clamp
Alerting operators when lifting equipment is reaching capacity
Details
Using a four wire strain bridge configuration, the cells put out 2mV/V and offer good linearity, repeatability and temperature stability. The design is simple, two roller bearing sheaves are mounted in a rigid frame. The rope is clamped in the middle of the load cell between the two sheaves. As tension increases the force against the two sheaves is transmitted as an electrical signal to the display as a direct reading of the line tension. Various Models are available.
Specifications
- Capacity 0.4-1.5t for rope sizes from 6-10mm
- Capacity 2-4t for rope sizes 11-16mm
- Capacity 4-10t for rope sizes 17-22mm
| Rated output | 2.0mV⁄V±0.1% |
|---|---|
| Accuracy class | 0.05 |
| Non-linearity | 0.05% F.S |
| Hysteresis | 0.05% F.S |
| Non-repeatability | 0.03% F.S |
| Creep in 30 minutes | 0.05% F.S |
| Temperature effect span | 30 PPM /°C of applied load |
| Temperature effect zero | 50 PPM /°C of applied load |
| Compensated temperature range | .10°C ~ 40°C |
| Operating temperature range | .40°C ~ 65°C |
| Zero balance | ±1% F.S |
| Input resistance | 770± 40Ω |
| Output resistance | 700± 5Ω |
| Safe overload | 150% F.S |
| Ultimate overload | 300% F.S |
| Excitation voltage | 10 VAC/DC |
| Maximum excitation voltage | 30 VAC/DC |
| Insulation resistance | > 2000MΩ (50V DC |
| Environmental protection | IP67 |
| Material | Alloy tool steel |
∗All specifications are a maximum as a percentage(±) of full load, unless otherwise stated.
| Capacity | Wire Force | Wire dia. | A | B | C | D | E | F | Weight |
|---|---|---|---|---|---|---|---|---|---|
| 06~10/1T | 0.4~3t | 6~10mm | 276 | 242 | 75 | 54 | 61 | 40 | 4.3kg |
| 11~16/4T | 2~5t | 11~16mm | 276 | 242 | 75 | 54 | 61 | 40 | 4.3kg |
| 17~22/5t | 4~10t | 17~22mm | 330 | 280 | 110 | 80 | 75 | 56 | 9.5kg |
Additional Documents
Terms and Conditions of Sale